A ready-cut house should not be confused with a sectional-portable house, which can be taken down and moved by being unbolted. A ready-cut house is a permanent house and the method of its construction is not different from any other frame house where the lumber is framed (or cut to its proper length, notched, etc.), by hand by carpenters.

All designs were standardized to maximize efficiency and reduce waste in materials and labor. Lumber and hardware were purchased in bulk. The factories had skilled employees and special machines to cut difficult pieces such as rafters and staircases. Lumber was pre-cut to length, guaranteed to fit, ready to nail, and labeled for easy assembly. Floor joists and bridging, sub-flooring, finished flooring, studs, rafters, sheathing, clapboards, shingles, stucco, plaster or drywall, columns, railings, doors and windows, hardware, nails, and paint for two exterior coats were included in the order. Plumbing, electrical, and heating systems were available for an additional charge. Although the lumber and hardware were standardized, the designs were not and buyers were encouraged to personalize their order. Many models had two or three floor plans, while the exterior could be clapboards, shingles, stucco, or framed for brick. Walls, windows, and doors could be moved, added or eliminated. Porches, sun rooms, flower boxes, trellises, balconies, built-in cabinets, and a variety of door and sash patterns were available at an additional charge.